Biofeedback Equipment NZ

NeuroTrac™ MyoPlus2 Bluetooth

$1,009.00 ex GST

Available on backorder

SKU: MYO220A Category:
  • The Classic Biofeedback / ETS / Stimulation device. A proper tool for training and progress assessment.
  • Pre-set programmes for Incontinence treatment, Sports and muscular development, neuro-muscular Rehabilitation.
  • Designed for Physiotherapist in mind to be used as a portable tool. Suitable as a personal trainer for in-clinic or home use (under guidance).
  • 2 channel EMG (Biofeedback) combined with 2 channels NMES (stimulation).
  • 2 channel ETS (EMG triggered stimulation) with stimulation on 2 channels.
  • Simple single-phase or multiphase operation: multiphase allows EMG/ETS/STIM to be combined in one programme.
  • Multilingual LCD screen and voice prompts for Biofeedback.
  • Manual and Automatic threshold control.
  • EMG Biofeedback between stimulation (muscle activity and tiredness indication when using muscle stimulation).
  • Stand alone device or used in conjunction with established multilingual software.
  • Now with Bluetooth connectivity! The unit sends up to 10 metres of  wireless data to PC software
  • For home users: Produces and prints (with the optional PC Software) the comprehensive patient progress reports on a day to day basis providing average readings (2 channels) on work/rest, peak, onset and muscle release times, work and rest deviations and the average mA current.
  • Used as a learning tool for both patient and clinician with emphasis on improving treatment techniques in the use of EMG and Neuromuscular stimulation.
  • 4 x AA batteries {No mains required}.

Specifications

EMG (Biofeedback)

  • Dual channel EMG
  • EMG Range: 0.2 to 2000 μV RMS (continuous)
  • Sensitivity: 0.l μV RMS
  • Accuracy: 4% of μV reading +/-0.3 μV at 200 Hz
  • Selectable Bandpass filter – 3db Bandwidth,
    • a. Wide: 18 Hz +/- 4 Hz to 370 Hz +/- 10% – Reading below 235 microvolts 10 Hz +/-3 Hz to 370 Hz +/- 10% – Reading above 235 microvolts
    • b. Narrow: 100 Hz +/- 5% to 370 Hz +/- 10%
  • Notch filter: 50 Hz (Canada 60Hz) – 33 dbs (0. 1% accuracy)
  • Common Mode Rejection Ratio: 130 dbs Minimum @ 50 Hz
  • Work / Rest periods: 2-99 seconds
  • Number of Trials: 1-99

STIM (Neuromuscular Stimulation)

  • Dual channel Stimulator
  • Amplitude: 0-90 mA into 500 Ohm load – actual mA will tend to be less
    than indicated due to Electrode impedance: at 1000 Ohms load (Electrodes
    in poor condition) the maximum will be limited to 75 mA, at 1500 Ohms
    load the maximum will be limited to 50 mA.
  • Type: Constant current, maximum output
    voltage 70 Volts +5 / -10 Volts
  • Waveform: Symmetrical, rectangular,
    bi-phasic with net zero DC current
  • Pulse width selection: 50-450 μS (2% accuracy)
  • Pulse rate selection: 2-100 Hz (2% accuracy)
  • Work / Rest periods: 2-99 seconds
  • Time 1 – 99 minutes
  • Ramp up time: 0.1 – 9.9 seconds
  • Preset and user programmable treatment Programs
  • Automatic output shut off with detection of open electrode above 0.5 mA

Battery: 4 x AA.  Low battery indication at 5.4 volts +/- 0.2 volts, automatic shut off when voltage dropps below the low indication. Replace the batteries immediately! The device goes off automatically when not in use (energy saving): for example when in settings and no key pressed over 1 minute, when in stimulation mode (home screen) and all channels are 0mA.

Expected average battery set life [of standard 800 mAh, alkaline]:
a. MyoPlus2:    12-16 hours in STIM, 25 hours in EMG mode.
b. MyoPlus4:    8-16 hours in  STIM, 25 hours in EMG mode.

Environmental Conditions for use: +10 to +30 degrees Centigrade. 0-90% Humidity.

Environmental conditions for storage & transport: -10 to +50 degrees Centigrade. 0-90% Humidity.

Physical dimensions: Length 150 mm, Width 89 mm, Depth 35 mm.

Weight: MyoPlus2 device: 0.16 Kg (without batteries).

Reviews

There are no reviews yet.

Be the first to review “NeuroTrac™ MyoPlus2 Bluetooth”

Your email address will not be published. Required fields are marked *